skip to main text

Positioning Originals (Scanning from Computer)

This section describes how to load originals on the platen or ADF (Auto Document Feeder) for scanning. If items are not placed correctly they may not be scanned correctly.

Important

  • Be sure to observe the following when loading the original on the platen. Failure to observe the following may cause the scanner to malfunction or the platen glass to break.

    • Do not place any objects weighing 4.4 lb (2.0 kg) or more on the platen glass.
    • Do not put any pressure of 4.4 lb (2.0 kg) or more on the platen glass, such as pressing down the original.
  • Close the document cover when scanning.
  • Do not touch the operation panel buttons or LCD (Liquid Crystal Display) when opening/closing the document cover. May result in unintended operation.

Placing Items (Platen)

Place items as described below to scan by detecting the item type and size automatically.

Important

  • When scanning by specifying the paper size in IJ Scan Utility or ScanGear (scanner driver), align an upper corner of the item with the corner at the arrow (alignment mark) of the platen.
  • Photos that have been cut to irregular shapes and items smaller than 1.2 inches (3 cm) square cannot be cropped accurately when scanning.
  • Reflective disc labels may not be scanned as expected.
Photos, Postcards, Business Cards, and BD/DVD/CD Magazines, Newspapers, and Documents
figure: Scan photos, postcards, business cards, or BD/DVD/CD

Single item:

Place the item face-down on the platen, with 0.4 inch (1 cm) or more space between the edges (diagonally striped area) of the platen and the item. Portions placed on the diagonally striped area cannot be scanned.

figure: Place a single item

Important

  • Large items (such as A4 size photos) that cannot be placed away from the edges/arrow (alignment mark) of the platen may be saved as PDF files. To save in a format other than PDF, scan by specifying the data format.

Multiple items:

Allow 0.4 inch (1 cm) or more space between the edges (diagonally striped area) of the platen and items, and between items. Portions placed on the diagonally striped area cannot be scanned.

figure: Place multiple items

: 0.4 inch (1 cm) or more

Note

  • Place up to 12 items.
  • Positions of slanted items (10 degrees or less) are corrected automatically.
figure: Scan magazines, newspapers, or documents

Place the item face-down on the platen and align an upper corner of the item with the corner at the arrow (alignment mark) of the platen. Portions placed on the diagonally striped area cannot be scanned.

figure: Place and align the item with the arrow

Important

Placing Documents (ADF (Auto Document Feeder))

Important

  • Be careful not to let anything get inside the document output slot. It may cause damage.
  • Place and align documents of the same size when scanning two or more documents.
  • For supported document sizes when scanning from the ADF, see Supported Originals.

Note

  • To scan a document at optimum quality, load it on the platen.
  1. Make sure any original has been removed from platen.

  2. Open document stopper (A).

  3. Open document tray (B).

  4. Slide the document guide (C) all the way out.

  5. Load document with side to scan facing up in document tray.

    Insert the document until it stops.

  6. Adjust document guide to match width of document.

    Do not slide the document guide too hard against the document. The document may not be fed properly.